SPE Drilling & Completion

Vol. 34 // No. 3          September 2019

 


Drilling

207–215
SPE-184660-PA

CFD Modeling of Hydraulic Behavior of Oil- and Water-Based Drilling Fluids in Laminar Flow

S. Sayindla, B. Lund, J. D. Ytrehus, and A. Saasen    

216–222
SPE-185281-PA

Strategic Evaluation of Managed Pressure Drilling: An Application on Brazilian Dynamic-Positioning Rigs

P. Esteves Aranha, D. Colombo, A. A. Fernandes, G. Siqueira Vanni, R. Akio Timita, C. B. de Campos Lima, G. B. Alves Lima, and J. C. de Faria Alvim Wasserman

223–247
SPE-194138-PA 

A Drill Bit and a Drilling Motor With Embedded High-Frequency (1600 Hz) Drilling Dynamics Sensors Provide New Insights Into Challenging Downhole Drilling Conditions

J. Sugiura and S. Jones

248–267
SPE-195689-PA  (Direct to Peer)

Borehole-Breathing/Kick Discriminator: Diagnostic Tool and Potential Resource for In-Situ Formation Characterization

S. Baldino, S. Z. Miska, E. M. Ozbayoglu, and J. Zhang

 


Completion

268–279
SPE-182529-PA             

Impact of Rotation During Installation on the Structural Performance of Slotted Liners in Thermally Stimulated Wells

M. A. Chartier, V. Y. B. Yung, and S. P. Taubner

280–295
SPE-187075-PA             

Multizone Casedhole Frac Packs and Intelligent-Well Systems Improve Recovery in Subsea Gas Fields

R. C. Burton, W. W. Gilbert, G. Fleming, J. C. Leitch, M. Nozaki, V. J. Pandey, M. D. Adams, E. M. Peterson, L. Zhou, and T. W. Ray

296–305
SPE-187318-PA             

Rapid Crosslinking Polymer Provides an Additional Blowout-Preventer Barrier

T. Nedwed, K. Kulkarni, R. Jain, D. Mitchell, B. Meeks, D. P. Allen, B. Edgecombe, and C. J. Cruce

306–314
SPE-191032-PA             

Triaxial Limit and Safety Factor of an Anisotropic Corrosion-Resistant Alloy Tubular

U. B. Sathuvalli, P. V. (Suri) Suryanarayana, S. Rahman, and S. Chandrasekhar

315–333
SPE-184444-PA             

Experimental Evaluation of Wellbore Flow Models Applied to Worst-Case-Discharge Calculations for Oil Wells

P. J. Waltrich, M. S. Capovilla, W. Lee, P. Cavalcanti de Sousa, M. Zulqarnain, R. Hughes, M. Tyagi, W. Williams, S. Kam, A. Archer, J. Singh, H. Nguyen, J. Duhon, and C. Griffith

334–344
SPE-194113-PA             

Evaluation of the Elevated-Temperature Performance and Degradation Mechanisms of Thread Compounds

D. Ernens, D. Westerwaal, R. F. H. Roijmans, E. J. van Riet, S. Daegling, A. Wheatley, E. Worthington, H. Kramer, W. M. van Haaften, M. Bas De Rooij, and H. R. Pasaribu