Evaluation of Limestone Formation Characteristics From Well Logs
- D.J. Cregeen (Qatar Petroleum Co., Ltd.) | H. Moir (Qatar Petroleum Co., Ltd.)
- Document ID
- Society of Petroleum Engineers
- Journal of Petroleum Technology
- Publication Date
- November 1961
- Document Type
- Journal Paper
- 1,087 - 1,092
- 1961. Original copyright American Institute of Mining, Metallurgical, and Petroleum Engineers, Inc. Copyright has expired.
- 5.5.2 Core Analysis, 4.3.1 Hydrates, 1.6.9 Coring, Fishing, 5.8.7 Carbonate Reservoir, 5.2 Reservoir Fluid Dynamics, 5.2.1 Phase Behavior and PVT Measurements, 5.6.2 Core Analysis, 4.3.4 Scale, 5.6.1 Open hole/cased hole log analysis
- 3 in the last 30 days
- 256 since 2007
- Show more detail
- View rights & permissions
The evaluation of limestone formations by well logs has brought many interesting problems to light, some of which are as yet unresolved. While a major purpose of well logging is to ensure that zones containing producible hydrocarbons are not bypassed, this paper is more concerned with the further information that can be derived from the logs to assist in more clearly defining reservoir characteristics, fluid content and performance. In the hard limestones of Southeast Arabia sufficient evidence has not yet been gathered to allow any large-scale tailoring of the logging program; a number of logs are still run which ostensibly can be used to compute the same parameter. The validity of some of these measurements is discussed, and some tentative interpretations are made concerning their significance. In this paper, the five selected topics are discussed in light of their application to the hard limestone reservoirs under review.
Water Saturation, Sw
Well-log analysis lends itself readily to the determination of water saturation and, hence, to computation of hydrocarbon reserves. However, it is advisable to obtain confirmation of the values so obtained by alternative methods because several factors influence the basic data from which these values are derived. As has been pointed out elsewhere, water saturations of 2 to 50 per cent of the available pore space have been observed in oil-producing formations. This wide range invalidates the possibility of choosing a reasonable value by inspecting the available choices and, thus, makes corroboration from other sources essential.
The methods used to determine connate-water saturation in the formations under review were core analysis of formations cut under oil-base mud, measurement of capillary pressures of cores and log analysis. Each of these methods suffers from limitations, and only where mutual agreement exists may a value be accepted with confidence. Since the log-analysis method offers distinct advantages over the other two, affording as it does a measurement under reservoir conditions, it was of interest to attempt to resolve the uncertainties inherent in the method by comparing results obtained on cores in the laboratory.
|File Size||478 KB||Number of Pages||6|